判断破碎锤大小基本的就是参考钎杆直径的大小，那么，挖掘机配破碎锤的时候，目前简单的就是参考挖掘机的重量，如下表（仅供参考）：钎杆直径mm4553687585100135140155165175适配车重ton1.2-3.02.5-4.54.0-7.06.0-9.07.0-1411-1618-2318-2628-3530-4540-55
The basic way to determine the size of the crushing hammer is to refer to the diameter of the drill rod. Therefore, when matching the crushing hammer with an excavator, the current simple method is to refer to the weight of the excavator, as shown in the table below (for reference only): the diameter of the drill rod mm4553687585100135140155165175, suitable for vehicle weight ton1.2-3.02.5-4.54.0-7.06.0-9.07.0-1411-1618-2318-2628-3530-4540-55
除此之外，还可以作为参考的有以下三个方面：
In addition, the following three aspects can also be used as references:
①挖掘机的油量：破碎锤的工作主要是依靠挖掘机的液压，所以，只有从挖掘机获得合适的液压，破碎锤才能发挥其佳性能。而一般情况下，破碎锤的流量为适配挖掘机流量的60%-80%。
① The oil volume of the excavator: The work of the crushing hammer mainly relies on the hydraulic pressure of the excavator, so only by obtaining appropriate hydraulic pressure from the excavator can the crushing hammer achieve its best performance. In general, the flow rate of the crushing hammer is 60% -80% of the flow rate of the suitable excavator.
②挖掘机的吐出压力：一般情况下，破碎锤的工作压力在低于挖掘机的常用压力的30-40bar的时候，破碎锤才能发挥出佳力量。
② The discharge pressure of the excavator: Generally, the working pressure of the crushing hammer is 30-40bar lower than the commonly used pressure of the excavator, and the crushing hammer can only exert its best force.
③挖掘机的提升能力：由于破碎锤是安装在挖掘机上使用的设备，所以挖掘机的提升能力必须能承受破碎锤的重量。否则挖掘机会有颠覆的可能，从而无法正常工作并且有隐患！
③ The lifting capacity of the excavator: As the crushing hammer is a device installed on the excavator, the lifting capacity of the excavator must be able to withstand the weight of the crushing hammer. Otherwise, there is a possibility of subversion in mining opportunities, resulting in inability to work properly and potential safety hazards!
破碎锤作业危险系数比较高，在此，军恒机械在此也提醒广大客户，一定要注意。作业时驾驶室要安装防护网，然后要观察作业现场附近是否有人员走动，以防有碎石块蹦出对人身造成伤害。
The risk factor of crushing hammer operation is relatively high. Here, Junheng Machinery also reminds customers to pay attention to safety. When working, the driver's cab should first be equipped with a protective net, and then observe whether there are any people moving around the work site to prevent any broken stones from jumping out and causing personal injury.
